|
[Sponsors] |
November 23, 2004, 10:15 |
I create an interpolator using
|
#1 |
Guest
Posts: n/a
|
I create an interpolator using the below command:
UInterpolator_ ( interpolation::New ( interpolationSchemes_, volPointInterpolation_, U_ ) ); I am guessing that a change in U_ will be taken into account, but will the point/node values be updated when U_ changes, or do I have to remove and create the interpolator at every timestep? If so, is there a way to only update the point values, so I do not have to recreate the interpolator for every timestep? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D interpolation | Nena | CFX | 0 | October 31, 2007 04:12 |
interpolation | rakesh | CFX | 1 | March 7, 2005 16:36 |
2D-Interpolation | Don Tron | Main CFD Forum | 3 | October 30, 2003 03:40 |
Interpolation res-->def | Stex | CFX | 2 | June 25, 2003 11:04 |
Interpolation | A. Mohamed | CFX | 1 | April 25, 2003 07:40 |