|
[Sponsors] |
October 16, 2010, 11:53 |
Change of B.C after solving !!!
|
#1 |
Senior Member
|
Dear Foamers,
i used buoyantBousiesqPimpleFoam to simulate a room ventilation. i defined B.C of inlet as temperature fixedValue 290K as seen below. Code:
boundaryField { wall { type zeroGradient; } inlet { type fixedValue; value uniform 290; } windows { type fixedValue; value uniform 305; } door { type fixedValue; value uniform 300; } } why is boundary fixed value changed? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |
Unknown error | sivakumar | OpenFOAM Pre-Processing | 9 | September 9, 2008 12:53 |
IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |
Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |