Home > Forums > Software User Forums > OpenFOAM

can I use cyclic boundary condition to modeling axisymmetric flow ?

Mark Forums Read

Reply

Search this Thread

July 8, 2011, 15:16	can I use cyclic boundary condition to modeling axisymmetric flow ?	#1
mechy Senior Member Join Date: Jun 2011 Posts: 163 Rep Power: 16	Hi all I want to simulate axi-symmetric flow using dsmcFoam but dsmcFoam can not handle wedge boundary condition can I use cyclic boundary condition to modeling axisymmetric flow ? I would be very appreciative if someone could help me Best Regards

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 06:45
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 06:21
Boundary condition issue, Modeling flow through spacer filled channel	asimsaeed	FLUENT	0	August 4, 2010 02:50
outflow boundary condition foe flow over a cylinder	Ardalan	Main CFD Forum	0	April 29, 2010 14:04
mass flow inlet boundary condition	vivian	FLUENT	5	April 21, 2006 07:23

All times are GMT -4. The time now is 11:03.