|
[Sponsors] |
Parallel run: How to send the geometry to the master process |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 25, 2011, 12:21 |
Parallel run: How to send the geometry to the master process
|
#1 |
New Member
Stefan Sicklinger
Join Date: Mar 2011
Posts: 7
Rep Power: 15 |
Hello,
I would like to couple OF to an external solver, therefore I need to gather all geometry information (nodal coords and face centers) of one specific patch in the master process. Is there any predefined construct in the PStream library (e.g. like reduce) which serves that purpose? Thank you very much in advance! Last edited by clean-energy; July 25, 2011 at 14:14. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SnappyHexMesh OF-1.6-ext crashes on a parallel run | norman1981 | OpenFOAM Bugs | 5 | December 7, 2011 12:48 |
Swap usage on parallel run | nikhilesh | OpenFOAM Running, Solving & CFD | 0 | April 30, 2009 09:50 |
Swap usage on parallel run | nikhilesh | OpenFOAM Bugs | 1 | April 30, 2009 04:42 |
Serial run OK parallel one fails | r2d2 | OpenFOAM Running, Solving & CFD | 2 | November 16, 2005 12:44 |
How to run parallel in ICEM_CFD? | Kiddo | Main CFD Forum | 2 | January 24, 2005 08:53 |