|
[Sponsors] |
[OpenFOAM] How to create Lables for isolines ? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 19, 2014, 08:17 |
How to create Lables for isolines ?
|
#1 |
Member
Pratik Nanavati
Join Date: May 2014
Location: Munich, Germany
Posts: 40
Rep Power: 12 |
Hello,
With reference to the attached image, I have created velocity contour using paraview filter. I was able to define the Range and Value through the filter settings. but I am not able to figure out how to give labels to these isolines ? (Range for the plotted isolines are -values to 0) |
|
Tags |
contour label, contours, isolines |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Using createPatch and cyclicAMI in FOAM Extend to create periodicbox | manuc | OpenFOAM Running, Solving & CFD | 1 | April 12, 2022 11:36 |
create the file *.foam | phongstar | OpenFOAM | 12 | October 14, 2018 18:06 |
[GAMBIT] How to plot S pipe | mariam.sara | ANSYS Meshing & Geometry | 36 | November 7, 2013 15:22 |
[ANSYS Meshing] is it possible to create virtual edges on the blades | er_ijaz | ANSYS Meshing & Geometry | 0 | November 3, 2013 05:15 |
[DesignModeler] Design Modeller create surface | papis | ANSYS Meshing & Geometry | 0 | October 31, 2013 13:52 |