Home > Forums > Visualization & Post-Processing Software > ParaView

[General] Mass-weighted average of temperature

Mark Forums Read

Reply

Search this Thread

March 4, 2019, 16:41	Mass-weighted average of temperature	#1
Superdude_123 New Member Mike Join Date: Feb 2018 Posts: 12 Rep Power: 7	I'm trying to setup a mass weighted average of temperature of a slice (Slice1) in Paraview. Are their any good steps on how to do this or could someone kindly walk me through it step by step? I've looked at some of the Ansys documentation, which covers integrating values, but I'm not really sure how I can integrate the right values, then pull them in to calculator. My experience with calculator has been limited in converting Kelvins in to Fahrenheit, but not pulling in integrated values.

Reply

Tags

integration, openfoam, paraview 4.0.1, temperature

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Specify Temperature of Inflowing Mass Source	JeffAnon	OpenFOAM Running, Solving & CFD	1	September 1, 2018 11:04
Near wall treatment in k-omega SST	Arnoldinho	OpenFOAM Running, Solving & CFD	38	March 8, 2017 13:48
Multiphase flow - incorrect velocity on inlet	Mike_Tom	CFX	6	September 29, 2016 01:27
Mass average temperature	simulate1	FLUENT	1	September 2, 2015 18:55
mass weighted average udf	mozafarie	Fluent UDF and Scheme Programming	0	December 17, 2013 07:13

All times are GMT -4. The time now is 17:18.