 |
 |
 |
|
|
|
[Sponsors] | ||||
[General] get spline source points into python macro |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 25, 2019, 15:45
|
get spline source points into python macro
|
#1 |
|
Senior Member
Giles Richardson
Join Date: Jun 2012
Location: Cambs UK
Posts: 115
Rep Power: 15  |
I want to use use the Paraview GUI to create some splines sources (placing the points by hand). Then I want to be able to access those spline point coordinates in the python script macro. How do I do this - is it even possible? Thanks
|
|
|
|
|
|
| Tags |
| macro, python, source, spline |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| polynomial BC | srv537 | OpenFOAM Pre-Processing | 4 | December 3, 2016 10:07 |
| [Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0 | Seroga | OpenFOAM Community Contributions | 9 | June 12, 2015 18:18 |
| [swak4Foam] funkySetFields compilation error | tayo | OpenFOAM Community Contributions | 39 | December 3, 2012 06:18 |
| pisoFoam compiling error with OF 1.7.1 on MAC OSX | Greg Givogue | OpenFOAM Programming & Development | 3 | March 4, 2011 18:18 |
| [blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 08:36 |
Linear Mode
