|
[Sponsors] |
[OpenFOAM] Unable to view the correct simulation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 2, 2021, 07:03 |
Unable to view the correct simulation
|
#1 |
New Member
Davide Molini
Join Date: Mar 2021
Posts: 1
Rep Power: 0 |
Hi everyone,
I am new to the forum and started using openFoam a few days ago. After simulating with openFoam the cavity tutorial, when i start the post-processing and open paraview with the command paraFoam, and after choosing the velocity field U, I'm left with something very different from what I'm supposed to obtain. And most importantly i'm left with something that isn't as detailed as in the tutorial. Does anyone have a clue on what's going on? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Unable to patch Cell Registered Region to define phase for multiphase simulation | allenpv | Fluent Multiphase | 1 | February 14, 2021 12:19 |
Transient simulation gives worse results than steady state simulation | jgross | CFX | 12 | January 21, 2021 12:21 |
Unable to view stl geometry in paraview after snappyHexMesh | Pratik Wani | OpenFOAM Pre-Processing | 1 | November 20, 2020 00:22 |
Can not get correct result in inducer simulation by pimpleDyMFoam | zxzx | OpenFOAM Running, Solving & CFD | 1 | February 19, 2017 02:43 |
Boundary condition setting regarding turbine simulation using CFX | Lacerlacer | CFX | 11 | March 12, 2012 09:32 |