 |
 |
 |
|
|
|
[Sponsors] | ||||
May 12, 2023, 16:26
|
Short streamlines
|
#1 |
|
New Member
Gerardo Zegers
Join Date: Apr 2015
Posts: 4
Rep Power: 11  |
Hi,
I want to create streamlines for a ChtMultiRegionFoam Model. This model has around 5M cells and runs without convergence problems. However, when I try to plot the lines using paraview (streamtracer) the streamlines end only after a short distance. I attached a picture of my fluid region and the obtained streamlines. Any ideas on how to solve this? The files are a little too heavy, so here is the vtk file for one timestep (exported using foamToVTK -poly -region fluido) : https://we.tl/t-UoToc5AZNc Best, Gerardo |
|
|
|
|
|
May 24, 2023, 07:11
|
|
#2 |
|
Super Moderator
Alex
Join Date: Jun 2012
Location: Germany
Posts: 3,400
Rep Power: 47 |
The stream tracer filter has a few settings that can help here.
Namely "maximum steps" and "maximum streamline length". Don't get confused by the slider for the latter option. You can enter a numerical value that is higher than the largest slider value. If all else fails and the streamlines keep stopping for no apparent reason, try switching the interpolator type to cell locator. |
|
|
|
|
|
 |
| Tags |
| chtmultiregionfoam, openfoam, paraview, streamlines break |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using streamlines for flow visualization and diverging residuals | kmiller | STAR-CCM+ | 1 | July 16, 2018 15:50 |
| streamlines too short | JohnJohn8 | OpenFOAM Post-Processing | 1 | November 28, 2016 16:31 |
| [General] Too short streamlines in Paraview | taalf | ParaView | 20 | February 25, 2016 20:04 |
| Interpreting streamlines of a rotating fan. | danbence | Visualization & Post-Processing | 1 | April 8, 2014 10:13 |
| [General] Problems with streamlines for 2D porous media flow simulations | twophaseflow | ParaView | 4 | February 11, 2014 14:32 |
Linear Mode
