|
[Sponsors] |
[OpenFOAM] How to tell paraFoam what data to use |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 13, 2009, 17:05 |
How to tell paraFoam what data to use
|
#1 |
Senior Member
BastiL
Join Date: Mar 2009
Posts: 530
Rep Power: 20 |
I have a minor problem I could not solve so far. Running paraFiew from a OF case for me always reads the data from the 0/ directory. However I want to read the last time. There is no option like -lastTime, so how can this be done.
Regards BastiL |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFD by anderson, chp 10.... supersonic flow over flat plate | varunjain89 | Main CFD Forum | 18 | May 11, 2018 07:31 |
[General] Advice on post processing compressor blade data in paraview | Jack001 | ParaView | 0 | February 4, 2016 17:16 |
redistributeMeshPar with scotch fails | matteoL | OpenFOAM Pre-Processing | 0 | March 30, 2015 11:13 |
How to setup a simple OpenFOAM cluster? | TommiPLaiho | OpenFOAM Installation | 3 | October 27, 2013 15:15 |
[OpenFOAM] Multiple independant data sets in paraFoam | christian | ParaView | 1 | August 27, 2007 12:30 |