|
[Sponsors] |
[OpenFOAM] PostProcessing of a tworegion mesh |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 15, 2006, 07:45 |
PostProcessing of a tworegion mesh
|
#1 |
Member
|
Hi all,
I'm working with a Conjugate solver that explicitly passes boundary conditions between solid and fluid interface. The two meshes are stored in two different directories: case/constant/region1/polyMesh case/constant/region2/polyMesh What I usually do to post-process is: - convert my result to VTK format with: foamToVTK . <casename> -mesh region1 foamToVTK . <casename> -mesh region2 - upload data in paraview for the two meshes separately This method works fine but is a little bit too long. In fact, as far as boundary data are not stored together with the internalField ones, it means that I have to load data for each boundary patch one by one (for each mesh) to obtain the complete field. I was just wondering if there was a better (faster and smarter) way of doing it. Thanks in advance for all your replies. Cosimo
__________________
Cosimo Bianchini Ergon Research s.r.l. Via Panciatichi, 92 50127 Florence - ITALY Tel: +39 055 0763716 Mob: +39 320 9460153 e-mail: cosimo.bianchini@ergonresearch.it URL: www.ergonresearch.it |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
[snappyHexMesh] Snappyhex mesh: poor inlet mesh | Swagga5aur | OpenFOAM Meshing & Mesh Conversion | 1 | December 3, 2016 16:59 |
3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |