|
[Sponsors] |
January 24, 2006, 05:24 |
Cutting plane
|
#1 |
Member
Anja Stretz
Join Date: Mar 2009
Posts: 92
Rep Power: 17 |
Hi,
I created a cutting plane with the "Filter cut". Now I would like to display only one side (one half) of the geomerty. Can someone please explain me how to do that? Or is there any other possibility to see what happens inside a 3D geometry? Thanks a lot, Anja |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] faceSet of a cutting plane for a internal patch definition | RubenGutiii | OpenFOAM Meshing & Mesh Conversion | 1 | April 17, 2019 05:10 |
Measure the surface of the faces of a triangulated cutting plane | Pagoda | OpenFOAM Post-Processing | 3 | August 20, 2018 09:51 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
Curiosity & Question about cutting plane through axisymmetric region | aerospain | OpenFOAM Post-Processing | 0 | October 4, 2012 04:05 |
plane cutting complex geometry in the middle | Lilly | FLUENT | 0 | July 27, 2011 09:01 |