 |
 |
 |
|
|
|
[Sponsors] | ||||
[OpenFOAM] Cut/Clip cylinder instead of sphere/plane? |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 30, 2011, 09:10
|
Cut/Clip cylinder instead of sphere/plane?
|
#1 |
|
New Member
Yu
Join Date: May 2010
Location: Cambridge, MA
Posts: 11
Rep Power: 16  |
Dear Foamers,
I would like to make a cut in paraview with the form of a cylinder. Is there any way I can do this? When using the cut command, I can only choose sphere or plane, but would like to have cylinder surface. Thanks all. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Flow past a 2D cylinder - High Re (1E+05) - Cd too high | Pervispasco | OpenFOAM Running, Solving & CFD | 4 | March 14, 2022 02:19 |
| Drag force coefficient too high for a flow past a cylinder using komega sst | Scabbard | OpenFOAM Running, Solving & CFD | 37 | March 21, 2016 16:16 |
| Forces Acting on a Rotating Cylinder (Moving Mesh) | dreamchaser | CFX | 5 | April 25, 2015 06:01 |
| Incorrect Drag and Drag Coefficient for flow over a cylinder | ozzythewise | Main CFD Forum | 8 | June 13, 2012 06:24 |
| [blockMesh] Specifying boundary faces failes in blockMesh | blaise | OpenFOAM Meshing & Mesh Conversion | 0 | May 10, 2010 03:56 |
Threaded Mode
