|October 27, 2009, 06:57||
Error in q1 file that contains PLANT coding!
Join Date: Mar 2009
Posts: 123Rep Power: 10
Hello all. I have fetched a problem with a q1 file that contains PLANT code. This is the sample q1 file (z117) in the phoenics. At first I run the virtual reality editor (runvre) then after execution I run the virtual earth (runear) in that time it shows the following error message-
I have checked with another q1 file that contains PLANT coding, but the result is same. But another q1 file are ok. I have attached the q1 file(z117)
How is the solution?? Can anyone give me some advice???
|error, phoenics, plant|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Transient boundary conditions||Jarrod Sinclair (Sinclair)||OpenFOAM Running, Solving & CFD||133||May 6, 2015 06:21|
|OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found||piprus||OpenFOAM Installation||22||February 25, 2010 14:43|
|Ground Coding Using PLANT||Alex||Phoenics||1||January 23, 2009 08:52|
|Paraview command not found||hardy||OpenFOAM Paraview & paraFoam||7||September 18, 2008 04:59|
|DxFoam reader update||hjasak||OpenFOAM Post-Processing||69||April 24, 2008 01:24|