|
[Sponsors] |
Anisotropic Tetrahedral Meshing using Gridgen? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 4, 2007, 22:53 |
Anisotropic Tetrahedral Meshing using Gridgen?
|
#1 |
Guest
Posts: n/a
|
Dear Friends,
I would like to apply "Anisotropic Tetrahedral Meshing" to the tutorial example 'Pierced-Elbow'. Well,.... I could not properly extrude the anisotropic tetrahedral meshes on the connectors along the Symmetry, Inflow and Outflow parts. Have you ever create the anisotropic tetrahedral meshes for the internal flow phenomena (e.g. the pierced-elbow)? Thanks a lot in advance.... Best regards, |
|
May 5, 2007, 12:22 |
Re: Anisotropic Tetrahedral Meshing using Gridgen?
|
#2 |
Guest
Posts: n/a
|
I have sucessfuly doen all th tutorials, please be patience, and do it again step by step by following the tutoial. regards
|
|
May 7, 2007, 08:13 |
Re: Anisotropic Tetrahedral Meshing using Gridgen?
|
#3 |
Guest
Posts: n/a
|
Dear Friends,
Then, have you also carried out the grid-generation for the internal flow phenomena (e.g. Pierced-Elbow problem) using Anisotropic Tetrahedral Meshing? Looking forward to your replying... Best regards, |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tetrahedral vs. Hexahedral Meshing for CFD | Andy Bartels | Main CFD Forum | 16 | September 20, 2019 11:06 |
Star Cd format output for 3D meshing using gridgen | sayeem | Main CFD Forum | 4 | March 30, 2011 00:24 |
Anisotropic surface meshing | fxzf | Main CFD Forum | 0 | March 7, 2011 06:21 |
'Tetrahedral meshing has failed for volume...' | Murat | FLUENT | 5 | February 19, 2011 05:22 |
tetrahedral meshing Codes | Heinz Wilkening | Main CFD Forum | 1 | August 26, 1998 15:03 |