Error in domain creation

viveknitdgp137 · November 16, 2019, 05:23

hi all,
I am unable to create an unstructured domain in pointwise via assemble special. can anyone suggest me what may be the problem?
In the figure after choosing the 2nd connector, I cannot choose the next connector(clockwise) which is in the XY plane.

Mainly I want to create a block around my aerofoil(around which I have already generated the inflation layer and created an aerofoil block) in my confined computational domain. Now after creating these two periodic surfaces when I chose to create an unstructured block it was saying some no. of connectors and domain were unused and the block was not created, Hence now I am trying to create separate surfaces(6) and then use assemble special to create a block.

Thanks in advance.

dgarlisch · November 18, 2019, 10:32

Zoom in at the corner where the selection stops. You may have nodes that are not properly connected (merged).

Can you attach the PW file?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Domain size influence in unbounded domains model	Reoyo	Main CFD Forum	10	May 4, 2018 08:30
Periodic Pressure drop	cfd_begin	CFX	10	May 25, 2017 07:09
Out File does not show Imbalance in %	Mmaragann	CFX	5	January 20, 2017 10:20
domain creation	sdeepaks.aero@gmail.com	CFX	5	August 28, 2015 07:56

November 18, 2019, 10:32		#2
dgarlisch Senior Member David Garlisch Join Date: Jan 2013 Location: Fidelity Pointwise, Cadence Design Systems (Fort Worth, Texas Office) Posts: 307 Rep Power: 14	Zoom in at the corner where the selection stops. You may have nodes that are not properly connected (merged). Can you attach the PW file?