|
[Sponsors] |
Non-conformal mesh interface and Pointwise |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 12, 2017, 12:44 |
Non-conformal mesh interface and Pointwise
|
#1 |
New Member
|
Is there a way to create a non-conformal mesh interface in pointwise?
I am trying to run a transient simulation for my horizontal axis wind turbine model using sliding mesh method but it seems that fluent solver has some issues with the conformal interface between the rotating cylinder and the enclosure resulting in creating a negative volume cells that cause the solver to fail. I tried to double and separate the interface domains or connectors but I failed even if I separate cylinder and enclosure in two layers. Any suggestions! |
|
Tags |
non-conformal interface, pointwise, sliding mesh method, transient solver |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D Sliding Mesh Interface | Tauseef | FLUENT | 0 | August 4, 2016 10:00 |
Pointwise Mesh to Fluent Multiblock Issue | NeroBlade | Pointwise & Gridgen | 7 | February 1, 2016 11:07 |
Volume mesh for Cyclone separator | Rajan | Pointwise & Gridgen | 17 | May 4, 2014 05:38 |
[Commercial meshers] Native OpenFOAM interface in Pointwise | cnsidero | OpenFOAM Meshing & Mesh Conversion | 41 | May 20, 2012 18:30 |
Native OpenFOAM interface in Pointwise | Chris Sideroff | Main CFD Forum | 0 | January 16, 2009 12:37 |