 |
 |
 |
|
|
|
[Sponsors] | ||||
March 25, 2020, 10:48
|
(pointwise) Source not modifying Connector
|
#1 |
|
Member
B.H.
Join Date: Nov 2014
Location: PA, USA
Posts: 47
Rep Power: 11  |
As stated in the title, the source will not modify, or in this example, refine, the sizing of the connector, thereby creating some unwelcome large cells. This is an unstructured mesh, by the way. Does Pointwise allow sources to modify connector spacing? If so, how do I work through that process?
Please see attached image. |
|
|
|
|
|
June 3, 2020, 03:52
|
|
#2 |
|
Senior Member
Louis Gagnon
Join Date: Mar 2009
Location: Stuttgart, Germany
Posts: 338
Rep Power: 18  |
Did you figure out the problem? I think you should have you domains (and connectors?) set to "adapt" in order for them to be influenced by sources
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Custom Thermophysical Properties | wsmith02 | OpenFOAM | 4 | June 1, 2023 14:30 |
| [foam-extend.org] Problems installing foam-extend-4.0 on openSUSE 42.2 and Ubuntu 16.04 | ordinary | OpenFOAM Installation | 19 | September 3, 2019 18:13 |
| polynomial BC | srv537 | OpenFOAM Pre-Processing | 4 | December 3, 2016 09:07 |
| [swak4Foam] funkySetFields compilation error | tayo | OpenFOAM Community Contributions | 39 | December 3, 2012 05:18 |
| pisoFoam compiling error with OF 1.7.1 on MAC OSX | Greg Givogue | OpenFOAM Programming & Development | 3 | March 4, 2011 17:18 |
Linear Mode
