|
[Sponsors] |
Pointwise introducing additional lines to the geometry |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 18, 2020, 10:33 |
Pointwise introducing additional lines to the geometry
|
#1 |
New Member
Tridib Banerjee
Join Date: Nov 2020
Posts: 1
Rep Power: 0 |
Hello,
I am facing this problem with pointwise when I import over a (.stp) geometry. It introduces additional lines into the geometry. So, basically, it looks like the geometry is the same as the design, but on zooming, each line is seen to be actually 2 or even 3 lines very close to eachother. This geometry was designed in Catia and in it, the geometry looks fine. I cannot figure out what the issue is and I tried searching online but nobody else seems to have experienced this issue yet. I am not allowed to share the files by my supervisor. Any help or suggestion would be really valuable. |
|
Tags |
extra lines, geometry change, import data, pointwise |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] Ansys Meshing splits geometry lines | Slurm | ANSYS Meshing & Geometry | 0 | March 22, 2017 13:13 |
Simulation of Flow through Complex 3D Geometry | EmersonKB | CFX | 5 | July 2, 2009 09:17 |
CFX Post - Inserting additional geometry | Andrew | CFX | 2 | April 18, 2007 09:27 |
vitual _ real | deneb | FLUENT | 3 | January 22, 2007 05:31 |
Virtual/Real geometry. | Jack Keays | FLUENT | 9 | June 16, 2000 00:39 |