|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Join Date: Oct 2010
Posts: 7
Rep Power: 16 ![]() |
Hi
I have a complicated geometry created in Pro/E that I cannot import without distortion in CFD-GEOM. So I am planning to use another software to do that. Pointwise can import the drawings all right and can mesh it properly. The problem is.... can I import a mesh generated in pointwise to ACE+? I see some common formats.. but am not sure if they will work. |
|
![]() |
![]() |
![]() |
Tags |
ace+, geom, pointwise, pro/e |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Native OpenFOAM interface in Pointwise | cnsidero | OpenFOAM Meshing & Mesh Conversion | 41 | May 20, 2012 19:30 |
Pointwise | Lodda | Pointwise & Gridgen | 0 | October 8, 2010 03:07 |
Pointwise | hm86 | Pointwise & Gridgen | 3 | September 4, 2010 21:57 |
[Technical] Unspecified boundary types in the grids created employing Pointwise | arash | OpenFOAM Meshing & Mesh Conversion | 5 | February 9, 2010 10:56 |
Native OpenFOAM interface in Pointwise | Chris Sideroff | Main CFD Forum | 0 | January 16, 2009 13:37 |