|
[Sponsors] |
November 17, 2023, 01:41 |
problem in maximum scour depth
|
#1 |
New Member
curious
Join Date: Mar 2023
Posts: 14
Rep Power: 3 |
Dear REEF3D team and other forum friends.
When I am doing a monopile simulation under pure wave, I found this phenomenon: the maximum scour depth shown in paraview post-processing does not match with the one shown in REEF3D_sedimentlog, and at some times, the difference between them can be up to double, may I know what causes the mismatch between them? What value should I base on? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SU2 Maximum Mesh Size Problem | Shbz | SU2 | 0 | January 17, 2022 14:34 |
UDF problem to obtain maximum temperature | erfan2000 | Fluent UDF and Scheme Programming | 3 | November 16, 2021 00:03 |
[Other] The problem regarding 3D scour using sedfoam | qi.yang@polimi.it | OpenFOAM Community Contributions | 0 | August 1, 2021 06:38 |
Flow over a circular cylinder, Re=8000, Problem with cd | david caseiro | FLUENT | 4 | October 10, 2017 10:18 |
problem gaining scour depth | nimaaghaie | FLOW-3D | 0 | April 29, 2015 10:30 |