Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: mattijs

Forum: OpenFOAM Meshing & Mesh Conversion

September 22, 2005, 12:35

Replies: 34

[Commercial meshers] Extension of fluentMeshToFoam internal cells and faces

Views: 6,282

Posted By mattijs

- you can make them (faceSets)

- you can make them (faceSets) into external patches using the splitMesh utility (discussed before)

- create a cellSet from the cells on one/both sides of the faceSet using the cellSet utility....

Forum: OpenFOAM Meshing & Mesh Conversion

September 20, 2005, 13:28

Replies: 34

[Commercial meshers] Extension of fluentMeshToFoam internal cells and faces

Views: 6,282

Posted By mattijs

> reports them in the order po

> reports them in the order points/faces/cells
No importance, just inconsistency.

You convert successfully from Gambit with gambitToFoam? Or does Gambit again write Fluent format?

From...

Forum: OpenFOAM Meshing & Mesh Conversion

September 20, 2005, 10:25

Replies: 34

[Commercial meshers] Extension of fluentMeshToFoam internal cells and faces

Views: 6,282

Posted By mattijs

Hi Håkan, does it convert i

Hi Håkan,

does it convert if you remove the internal patches? Does the mesh have any 'split' hexes? Did you have any luck with 'normal' cellShapes?

Forum: OpenFOAM Meshing & Mesh Conversion

March 24, 2005, 08:34

Replies: 34

[Commercial meshers] Extension of fluentMeshToFoam internal cells and faces

Views: 6,282

Posted By mattijs

Ad 2) send it to me and I'll h

Ad 2) send it to me and I'll have a look at it. Address is m.janssens at opencfd.co.uk

A small testcase would be nice as well - we don't have Gamibt over here.

Mattijs

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 08:08.