Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: pogbodo

Forum: ANSYS Meshing & Geometry

March 12, 2015, 17:26

Replies: 13

[DesignModeler] Boolean operation failed

Views: 4,224

Posted By pogbodo

Hi Amin.z, Thank you so much for your help....

Hi Amin.z,

Thank you so much for your help. I truly appreciate it.

Regards,

Precious.

Forum: ANSYS Meshing & Geometry

March 11, 2015, 08:08

Replies: 13

[DesignModeler] Boolean operation failed

Views: 4,224

Posted By pogbodo

Hi Amin, Sorry, I'm new to modelling hence...

Hi Amin,

Sorry, I'm new to modelling hence I don't understand much.

I have attached the geometry below.

Thanks for your help.

Regards

Forum: ANSYS Meshing & Geometry

March 11, 2015, 05:11

Replies: 13

[DesignModeler] Boolean operation failed

Views: 4,224

Posted By pogbodo

Hi Amin, I don't understand. Is the use of...

Hi Amin,

I don't understand. Is the use of trim not applicable to lines? Well, I tried it as suggested but it trimmed off the lines of the circle.

I want to remove the circular surface from the...

Forum: ANSYS Meshing & Geometry

March 11, 2015, 03:03

Replies: 13

[DesignModeler] Boolean operation failed

Views: 4,224

Posted By pogbodo

Hi Kapi, They are different parts. The...

Hi Kapi,

They are different parts.

The warning message is:

Operation would result to non-manifold bodies.
Context: Geometry Engine; while generating Feature Boolean1

Thanks for your...

Forum: ANSYS Meshing & Geometry

March 10, 2015, 13:07

Replies: 13

[DesignModeler] Boolean operation failed

Views: 4,224

Posted By pogbodo

Sorry, that didn't work either.

Sorry, that didn't work either.

Forum: ANSYS Meshing & Geometry

March 10, 2015, 10:54

Replies: 13

[DesignModeler] Boolean operation failed

Views: 4,224

Posted By pogbodo

Hiya, Yes, I did. The target body is the...

Hiya,

Yes, I did. The target body is the rectangle's surface body, and the tool body the cylinder's. I think the problem is, because the cylinder rests on the rectangle it cannot subtract.

Is...

Forum: ANSYS Meshing & Geometry

March 9, 2015, 16:09

Replies: 13

[DesignModeler] Boolean operation failed

Views: 4,224

Posted By pogbodo

Boolean operation failed

Hi everyone,

I'm in need of urgent help pls.

I tried creating a boolean subtraction, i.e, to subtract the cylinder surface from the rectangular domain as in the picture below, but it didn't...

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -4. The time now is 02:14.