Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: tuna

Forum: ANSYS Meshing & Geometry

November 7, 2015, 01:48

Replies: 7

Poll: [ANSYS Meshing] mesh of pipe which inserted a wire coil in this pipe

Views: 1,643

Posted By tuna

mesh of pipe which inserted a wire coil in this pipe

because, I used both of them but it gives error.

Forum: ANSYS Meshing & Geometry

November 6, 2015, 09:07

Replies: 7

Poll: [ANSYS Meshing] mesh of pipe which inserted a wire coil in this pipe

Views: 1,643

Posted By tuna

mesh of pipe which inserted a wire coil in this pipe

thank you for answer but I can not understand. front face - face meshing ? or under sweep method manuel source and target?

Forum: ANSYS Meshing & Geometry

November 5, 2015, 08:33

Replies: 7

Poll: [ANSYS Meshing] mesh of pipe which inserted a wire coil in this pipe

Views: 1,643

Posted By tuna

sweep mesh and mapped face error

Dear Antanas,

I used sliced features in DM. I seperate 5 parts. This parts is done with using add frozen features but coil is sliced material. But I can not use sweep mesh, mapped mesh and...

Forum: ANSYS Meshing & Geometry

September 18, 2015, 10:50

Replies: 7

Poll: [ANSYS Meshing] mesh of pipe which inserted a wire coil in this pipe

Views: 1,643

Posted By tuna

Do you have any idea ? Gambit ?

Do you have any idea ? Gambit ?

Forum: ANSYS Meshing & Geometry

September 18, 2015, 09:24

Replies: 7

Poll: [ANSYS Meshing] mesh of pipe which inserted a wire coil in this pipe

Views: 1,643

Posted By tuna

mesh of pipe which inserted a wire coil in this pipe

Hi everyone

I want to do mesh like below figure but I dont know which type of mesh is suitable. I applied the hex dominant mesh sytle but as I did not want. Can you help me ?

Best wishes

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 07:23.