Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: funkvps

Forum: ANSYS Meshing & Geometry

August 2, 2017, 04:53

Replies: 15

[DesignModeler] How to substract the whole body if the body is partial overlap with the tool body

Views: 1,094

Posted By funkvps

The red pointed space will make some cells with...

The red pointed space will make some cells with skewness value larger than 0.95 during sweep meshing, finally cause the k-eplison to unable to converge

Forum: ANSYS Meshing & Geometry

August 2, 2017, 04:49

Replies: 15

[DesignModeler] How to substract the whole body if the body is partial overlap with the tool body

Views: 1,094

Posted By funkvps

This will not work, as enlarge the dia of the...

This will not work, as enlarge the dia of the holes embedded on the plate will make the previous non-narrow space to be narrow space, even this will also make some previous narrow space away.

Forum: ANSYS Meshing & Geometry

August 2, 2017, 04:48

Replies: 15

[DesignModeler] How to substract the whole body if the body is partial overlap with the tool body

Views: 1,094

Posted By funkvps

Correct!:p Shell side flow path analysis of...

Correct!:p

Shell side flow path analysis of shell & tube exchanger with different kinds of baffles

Forum: ANSYS Meshing & Geometry

August 2, 2017, 01:58

Replies: 15

[DesignModeler] How to substract the whole body if the body is partial overlap with the tool body

Views: 1,094

Posted By funkvps

Now new problems comes out. For some of the...

Now new problems comes out.

For some of the location, after the subtract, there will be a very narrow space, which will result in a very urgly.

Any suggestions for this?

From my point, if we...

Forum: ANSYS Meshing & Geometry

August 2, 2017, 01:53

Replies: 15

[DesignModeler] How to substract the whole body if the body is partial overlap with the tool body

Views: 1,094

Posted By funkvps

China :):D

China :):D

Forum: ANSYS Meshing & Geometry

August 1, 2017, 05:00

Replies: 15

[DesignModeler] How to substract the whole body if the body is partial overlap with the tool body

Views: 1,094

Posted By funkvps

amazing method. thanks!

amazing method. thanks!

Forum: ANSYS Meshing & Geometry

July 31, 2017, 10:30

Replies: 15

[DesignModeler] How to substract the whole body if the body is partial overlap with the tool body

Views: 1,094

Posted By funkvps

How to substract the whole body if the body is partial overlap with the tool body

Hello, everyone,

I have faced an annoy request during automation of parameter model in design modeler.

Please refer to the attached Picture, I'm seeking for a automatic method for substract the...

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -4. The time now is 16:59.