Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: gav

Forum: ANSYS Meshing & Geometry

January 3, 2011, 07:57

Replies: 12

[ICEM] Rotating Tyre Meshing

Views: 5,081

Posted By gav

Dothan, I did end up getting it to run. The...

Dothan,
I did end up getting it to run. The contact point I changed to a depressed section on the tyre so the contact is a defined area rather than a line (with the tangential contact I had before...

Forum: ANSYS Meshing & Geometry

October 24, 2010, 08:49

Replies: 12

[ICEM] Rotating Tyre Meshing

Views: 5,081

Posted By gav

Got it to work. Thanks for the help everyone....

Got it to work. Thanks for the help everyone. What Simon said about tetra being easier for beginners is definitley correct. Here's the a post picture if anyone's interested:
5076

Forum: ANSYS Meshing & Geometry

October 16, 2010, 00:13

Replies: 12

[ICEM] Rotating Tyre Meshing

Views: 5,081

Posted By gav

Ok so I've tried to clean up the geometry a bit,...

Ok so I've tried to clean up the geometry a bit, the only edges are now the boundary box edges and the contact point between the tyre and the road. I've also got a fairing in front of the tyre (I...

Forum: ANSYS Meshing & Geometry

October 14, 2010, 00:35

Replies: 12

[ICEM] Rotating Tyre Meshing

Views: 5,081

Posted By gav

Thanks sarangdalne that's good advice about...

Thanks sarangdalne that's good advice about intersecting surfaces but I'm still having issues. What mesh type did you use for your model? And did yours have a volume mesh as well? And when you say...

Forum: ANSYS Meshing & Geometry

October 13, 2010, 05:43

Replies: 12

[ICEM] Rotating Tyre Meshing

Views: 5,081

Posted By gav

Rotating Tyre Meshing

Hi everyone,

I was hoping someone could give me a bit of advice for meshing a model of a tyre so that it can later be set to a rotating wall bc in CFX. The tyre is just a simple cylindrical shape...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 01:10.