Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: Raza Javed

Forum: OpenFOAM Running, Solving & CFD

May 2, 2019, 11:32

Replies: 16

Configuration of boundary conditions and fvOptions file

Views: 2,624

Posted By Raza Javed

Hello LuckyTran, My version of OpenFoam...

Hello LuckyTran,

My version of OpenFoam is 4.1.

I have one question.

I have searched alot on this forum and almost everywhere else. No one even encountered this error. Probably, I am...

Forum: OpenFOAM Running, Solving & CFD

April 26, 2019, 11:16

Replies: 16

Configuration of boundary conditions and fvOptions file

Views: 2,624

Posted By Raza Javed

Thank you so much. So, it means...

Thank you so much.

So, it means that to get the power of 1000W I need to put value (h (0.001 0)) in fvOption file?

And if I put the value of "h" as (0.001 0) then the simulation...

Forum: OpenFOAM Running, Solving & CFD

April 26, 2019, 10:40

Replies: 16

Configuration of boundary conditions and fvOptions file

Views: 2,624

Posted By Raza Javed

I have edited my fvoptions file like this: ...

I have edited my fvoptions file like this:

heatSource
{
type scalarSemiImplicitSource;
active true;

scalarSemiImplicitSourceCoeffs
{

Forum: OpenFOAM Running, Solving & CFD

April 26, 2019, 10:12

Replies: 16

Configuration of boundary conditions and fvOptions file

Views: 2,624

Posted By Raza Javed

Here is the result of the simulation, when I run...

Here is the result of the simulation, when I run my case.

Forum: OpenFOAM Running, Solving & CFD

April 26, 2019, 10:05

Replies: 16

Configuration of boundary conditions and fvOptions file

Views: 2,624

Posted By Raza Javed

Thank you so much for your reply. I am...

Thank you so much for your reply.

I am sorry I am new to openfoam... I want to make only my hot box a heat source (Does it mean that all the cells of hot box will have a separate heat source?)....

Forum: OpenFOAM Running, Solving & CFD

April 26, 2019, 05:13

Replies: 16

Configuration of boundary conditions and fvOptions file

Views: 2,624

Posted By Raza Javed

Configuration of boundary conditions and fvOptions file

Hello everyone,

I am implementing the chtMultiRegionSimpleFoam. My geometry consists of three solid regions (Hot, Cold and Pipe). Hot box and Cold box are connected using pipe between them.

...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 11:55.