Search Results

Showing results 1 to 8 of 8
Search took 0.01 seconds. Search: Posts Made By: Far

Forum: ANSYS Meshing & Geometry

March 10, 2017, 14:10

Replies: 15

[ICEM] Setting Periodic Boundary Conditions

Views: 12,173

Posted By Far

this can be done

this can be done

Forum: ANSYS Meshing & Geometry

February 6, 2012, 12:58

Replies: 15

[ICEM] Setting Periodic Boundary Conditions

Views: 12,173

Posted By Far

I guess that base point is important in 2-D...

I guess that base point is important in 2-D vertical wind turbine periodic setup, where you pivot the whole mesh.
Vertical wind turbine...

Forum: ANSYS Meshing & Geometry

January 30, 2012, 11:55

Replies: 15

[ICEM] Setting Periodic Boundary Conditions

Views: 12,173

Posted By Far

I also use similar method, I go to global mesh...

I also use similar method, I go to global mesh settings and set the required angle and axis. Since currently I am working on bladegen and get the turbine or compressor file from there, I normally...

Forum: ANSYS Meshing & Geometry

January 30, 2012, 11:50

Replies: 15

[ICEM] Setting Periodic Boundary Conditions

Views: 12,173

Posted By Far

What I want to say is that, any software should...

What I want to say is that, any software should be intelligent enough to understand the basic requirements.
For example

1. if you increase the sector from 90 to 120, you again need to copy the...

Forum: ANSYS Meshing & Geometry

January 30, 2012, 10:06

Replies: 15

[ICEM] Setting Periodic Boundary Conditions

Views: 12,173

Posted By Far

I dont think so you could get periodicity in this...

I dont think so you could get periodicity in this way!!!!

Forum: ANSYS Meshing & Geometry

January 30, 2012, 09:47

Replies: 15

[ICEM] Setting Periodic Boundary Conditions

Views: 12,173

Posted By Far

Hi Arjun, I am unable to understand that...

Hi Arjun,

I am unable to understand that what is the purpose of all this in ICEM. If you just export the mesh with periodic boundaries as wall, you can still make them periodic in Fluent.

Forum: ANSYS Meshing & Geometry

January 29, 2012, 22:37

Replies: 15

[ICEM] Setting Periodic Boundary Conditions

Views: 12,173

Posted By Far

This is the what I found from the ICEM 10...

This is the what I found from the ICEM 10 tutorial guide.
3.15. Periodicity
Periodic definition may be applied to the model in Hexa. The Periodic nodes function, which is found under Blocking >...

Forum: ANSYS Meshing & Geometry

January 27, 2012, 15:10

Replies: 15

[ICEM] Setting Periodic Boundary Conditions

Views: 12,173

Posted By Far

Check this...

Check this (http://www.cfd-online.com/Forums/ansys-meshing/72756-periodic-compressor-geom-mesh.html)

Showing results 1 to 8 of 8

Forum Jump

All times are GMT -4. The time now is 18:19.