Search Results

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: Far

Forum: ANSYS Meshing & Geometry

April 8, 2012, 14:20

Replies: 11

[ICEM] How to build the mesh for 3 injection area within one surface?

Views: 2,182

Posted By Far

@Ralen : I apologise that I didn't understand...

@Ralen : I apologise that I didn't understand your comment. You are correct . Thats why inner block was distorted. Thanks

Forum: ANSYS Meshing & Geometry

April 8, 2012, 14:04

Replies: 11

[ICEM] How to build the mesh for 3 injection area within one surface?

Views: 2,182

Posted By Far

I have found one mistake in part I at 3:11 where...

I have found one mistake in part I at 3:11 where I have associated four edges to two curves and in reality there were three curves (one is very small). ...

Forum: ANSYS Meshing & Geometry

April 4, 2012, 06:30

Replies: 11

[ICEM] How to build the mesh for 3 injection area within one surface?

Views: 2,182

Posted By Far

Actually Ralen is referring to video where the...

Actually Ralen is referring to video where the inner most blocks was adjusted. Also he is referring to wrong edge-curve association, which was later corrected in part II (Or part I, I am not sure...

Forum: ANSYS Meshing & Geometry

April 4, 2012, 04:59

Replies: 11

[ICEM] How to build the mesh for 3 injection area within one surface?

Views: 2,182

Posted By Far

Ah, some small adjustments are still needed. My...

Ah, some small adjustments are still needed. My primary aim was to clarify the process of creating the o-block and getting different inlets with different boundary conditions in Fluent (Obviously...

Forum: ANSYS Meshing & Geometry

April 3, 2012, 13:04

Replies: 11

[ICEM] How to build the mesh for 3 injection area within one surface?

Views: 2,182

Posted By Far

Video clips - Youtube

Part I

http://www.youtube.com/watch?v=9OjpfNELv9c&feature=relmfu

Part II

http://www.youtube.com/watch?v=56mEO6_2Ohc&feature=youtu.be

Part III

Forum: ANSYS Meshing & Geometry

April 3, 2012, 08:51

Replies: 11

[ICEM] How to build the mesh for 3 injection area within one surface?

Views: 2,182

Posted By Far

here is the little effort made by me. I checked...

here is the little effort made by me. I checked them in fluent and every thing is fine.

I am also uploading 3 parts video on youtube and shall post links in next post.

...

Showing results 1 to 6 of 6

Forum Jump

All times are GMT -4. The time now is 10:16.