Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: adityaRaman

Forum: CONVERGE

August 6, 2020, 01:08

Replies: 13

Negative Cp in therm.dat

Views: 2,361

Posted By adityaRaman

If you are still having the same issue, please...

If you are still having the same issue, please feel free to reach out to us at support@convergecfd.com (US); supportEU@convergecfd.com (EU) or support.in@convergecfd.com (India) with your case setup....

Forum: CONVERGE

August 6, 2020, 01:06

Replies: 13

Negative Cp in therm.dat

Views: 2,361

Posted By adityaRaman

Hello Alireza, Which version of Studio...

Hello Alireza,

Which version of Studio are you currently using? Try updating it to the most recent one. You will see an option to enable transport, similar to the attached figure. If you have...

Forum: CONVERGE

July 30, 2020, 07:41

Replies: 13

Negative Cp in therm.dat

Views: 2,361

Posted By adityaRaman

You would have to check on the Enable Transport...

You would have to check on the Enable Transport option under Mechanism Reduction > Target Species and tolerances > Isomer Lumping tab in Studio.

After this you will have to include your...

Forum: CONVERGE

July 29, 2020, 03:41

Replies: 13

Negative Cp in therm.dat

Views: 2,361

Posted By adityaRaman

Hi Alireza, The transport data for lumped...

Hi Alireza,

The transport data for lumped isomers should be written along with the mechanism data. Can you describe what you were trying to do and when the following error happens?

...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 14:54.