Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: PSYMN

Forum: ANSYS Meshing & Geometry

September 4, 2013, 14:06

Replies: 12

[ICEM] Delnauy technique "Bottom-up" problem

Views: 2,094

Posted By PSYMN

Actually, I guess you were using patch conforming...

Actually, I guess you were using patch conforming mesh right? THe internal wall thing is just to prevent octree from deleting the mesh so there will be mesh for prism to grow from... If you are...

Forum: ANSYS Meshing & Geometry

September 4, 2013, 13:23

Replies: 12

[ICEM] Delnauy technique "Bottom-up" problem

Views: 2,094

Posted By PSYMN

The trailing edge surface should be longer (at...

The trailing edge surface should be longer (at least the element size times the number of layers) and did you make sure to set the "internal wall" and "prism" check boxes for the new surface? It...

Forum: ANSYS Meshing & Geometry

September 2, 2013, 21:22

Replies: 12

[ICEM] Delnauy technique "Bottom-up" problem

Views: 2,094

Posted By PSYMN

1) I think the actual minimum that it will accept...

1) I think the actual minimum that it will accept is 1e-6 for quality.

2) The trailing edge surface will improve the prism quality which will then allow prism to grow as you expect

3) I have...

Forum: ANSYS Meshing & Geometry

September 1, 2013, 15:57

Replies: 12

[ICEM] Delnauy technique "Bottom-up" problem

Views: 2,094

Posted By PSYMN

My guess is that the element quality of folding...

My guess is that the element quality of folding the prisms around that curve was just too low. You could lower the min quality to get more prisms, but...

When I have a sharp trailing edge, I...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 01:29.