Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: Selina_stj

Forum: ANSYS

May 20, 2011, 05:18

Replies: 9

compressor shroud clearance

Views: 2,463

Posted By Selina_stj

Hi Far, Thank you for your suggestions. I tried...

Hi Far, Thank you for your suggestions. I tried before as you suggested . But it could not work because my meshes is too big and too complacated. Why I set the shroud tip boundary to wall just...

Forum: ANSYS

May 19, 2011, 14:04

Replies: 9

compressor shroud clearance

Views: 2,463

Posted By Selina_stj

yes, you are right

yes, you are right

Forum: ANSYS

May 19, 2011, 13:23

Replies: 9

compressor shroud clearance

Views: 2,463

Posted By Selina_stj

Hi Far, the interface is generated automatically...

Hi Far, the interface is generated automatically in TurboGrid.
And it's helpful for me because my meshes is too big. If I run the simulation immediately with the whole mesh. It's impossible to...

Forum: ANSYS

May 19, 2011, 10:07

Replies: 9

compressor shroud clearance

Views: 2,463

Posted By Selina_stj

Hi Far, thank you for your reply. The pictures is...

Hi Far, thank you for your reply. The pictures is added to my questions

Forum: ANSYS

May 18, 2011, 10:08

Replies: 9

compressor shroud clearance

Views: 2,463

Posted By Selina_stj

compressor shroud clearance

Hi everyone, for last few months, I use CFX 12 to simulate the compressor fluid without acitivating the shroud clearance by setting wall boundaries to the interface at the tip of blades. But to...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 21:36.