Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: Ralen

Forum: ANSYS Meshing & Geometry

September 21, 2011, 06:26

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 9,001

Posted By Ralen

Sorry. In the first post four pictures: the first...

Sorry. In the first post four pictures: the first three of them made by me, and the last of the ICEM CFD HELP. I want to get a mesh like the last picture. But in my case I need to do 8 Y-blocks.

Forum: ANSYS Meshing & Geometry

September 21, 2011, 04:35

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 9,001

Posted By Ralen

And what this mesh is different from mine, shown...

And what this mesh is different from mine, shown in the first post? :) Do not solve the main problem: the sharp angles of triangular surface mesh is bad.

Forum: ANSYS Meshing & Geometry

September 20, 2011, 10:28

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 9,001

Posted By Ralen

STL file. This is part of the diffuser as shown...

STL file. This is part of the diffuser as shown in the first message. I'm just trying to build a grid separately.

Forum: ANSYS Meshing & Geometry

September 20, 2011, 07:45

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 9,001

Posted By Ralen

Geometry http://www.sendspace.com/file/3zmvok....

Geometry http://www.sendspace.com/file/3zmvok. ICEM Project is attached in the first post. I'm here about that if I remove the block, then lost two vertices at the corner. In total, four such blocks...

Forum: ANSYS Meshing & Geometry

September 20, 2011, 07:05

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 9,001

Posted By Ralen

I remove all the blocks, creating a 3d box for...

I remove all the blocks, creating a 3d box for all the geometry and divide it into 4 equal square blocks. I did not remove the block and create Quarter O-Grid on it, because I need / \ (upside down Y...

Forum: ANSYS Meshing & Geometry

September 20, 2011, 03:45

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 9,001

Posted By Ralen

Here's how it happened to one corner. Somewhere...

Here's how it happened to one corner. Somewhere there was another grid.

Forum: ANSYS Meshing & Geometry

September 19, 2011, 02:18

Replies: 15

[ICEM] Y-block on curved surfaces

Views: 9,001

Posted By Ralen

Y-block on curved surfaces

Hi All.
How do I build the same Y-blocks as shown in the ICEM help?
ICEM Project http://www.sendspace.com/file/ygl9nw

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -4. The time now is 07:41.