Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: m5edr

Forum: ANSYS Meshing & Geometry

June 3, 2013, 10:47

Replies: 9

[ICEM] Why Prism Incomplete?

Views: 1,551

Posted By m5edr

I knew the prisms usually have low quality but...

I knew the prisms usually have low quality but Fluent not always comfortable with this low quality and always notify for this issue , and during my little expiercnce , Fluent may be not accept the...

Forum: ANSYS Meshing & Geometry

June 1, 2013, 04:25

Replies: 9

[ICEM] Why Prism Incomplete?

Views: 1,551

Posted By m5edr

Yes I read this tips before But 180 prism angle...

Yes I read this tips before But 180 prism angle where this angle prevent pyramids but also make worst prism quality.. However thanks for your recommendations :)

Forum: ANSYS Meshing & Geometry

June 1, 2013, 04:19

Replies: 9

[ICEM] Why Prism Incomplete?

Views: 1,551

Posted By m5edr

I tried these steps BUT nothing new , the same...

I tried these steps BUT nothing new , the same results of incomplete prism

I attached my files (the prism setup is found there)

Forum: ANSYS Meshing & Geometry

May 25, 2013, 07:34

Replies: 9

[ICEM] Why Prism Incomplete?

Views: 1,551

Posted By m5edr

I did this step But the same error in prism also...

I did this step But the same error in prism also produced (see figure)

Forum: ANSYS Meshing & Geometry

May 24, 2013, 23:03

Replies: 9

[ICEM] Why Prism Incomplete?

Views: 1,551

Posted By m5edr

Why Prism Incomplete?

Hi Experts

I built a simple prism around wind turbine blade (see picture 1) BUT the Prism is Incomplete along the blade (see picture 2) , for the prism parameters (see picture 3). Why?

Thanks...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 12:25.