Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: Gimlas

Forum: OpenFOAM Meshing & Mesh Conversion

March 27, 2020, 11:31

Replies: 14

[Gmsh] GMSH to OPenFOAM - What am I doing wrong?

Views: 5,136

Posted By Gimlas

I was forced to use the open-license sotwere (I...

I was forced to use the open-license sotwere (I have some experience using ANSYS Fluent but it could not be used in this case). When I asked for advice for the best meshing software everyone told me...

Forum: OpenFOAM Meshing & Mesh Conversion

March 27, 2020, 02:15

Replies: 14

[Gmsh] GMSH to OPenFOAM - What am I doing wrong?

Views: 5,136

Posted By Gimlas

Hi alexeym, The problem appears only when...

Hi alexeym,

The problem appears only when the geometry is created via stp file import. In all other cases everything works fine. And the stp file is ok - it was used in ANSYS MESH and in Salome...

Forum: OpenFOAM Meshing & Mesh Conversion

March 24, 2020, 16:58

Replies: 14

[Gmsh] GMSH to OPenFOAM - What am I doing wrong?

Views: 5,136

Posted By Gimlas

Your advise works as long as I am using geometry...

Your advise works as long as I am using geometry generated in GMSH. Then, everything works fine. But when I've exported a step file another problem appeard. Take a look on the screenshots. When the...

Forum: OpenFOAM Meshing & Mesh Conversion

March 23, 2020, 20:26

Replies: 14

[Gmsh] GMSH to OPenFOAM - What am I doing wrong?

Views: 5,136

Posted By Gimlas

Thank you for your answer. The mesh also works...

Thank you for your answer. The mesh also works for me.

Concluding the problem is at the stage of mesh export. I've asked my colleague to download gmsh and generate a simple mesh of any random...

Forum: OpenFOAM Meshing & Mesh Conversion

March 22, 2020, 09:57

Replies: 14

[Gmsh] GMSH to OPenFOAM - What am I doing wrong?

Views: 5,136

Posted By Gimlas

Could it be an issue with the GMSH 4.5.4? I've...

Could it be an issue with the GMSH 4.5.4? I've tried to walk around this problem. I've exported the mesh into nastran file, then it was imported to fluent. In fluent also no boundaries were visible...

Forum: OpenFOAM Meshing & Mesh Conversion

March 21, 2020, 14:00

Replies: 14

[Gmsh] GMSH to OPenFOAM - What am I doing wrong?

Views: 5,136

Posted By Gimlas

Dear mzzmrt, The volume did not solve the...

Dear mzzmrt,

The volume did not solve the problem:

Forum: OpenFOAM Meshing & Mesh Conversion

March 20, 2020, 06:33

Replies: 14

[Gmsh] GMSH to OPenFOAM - What am I doing wrong?

Views: 5,136

Posted By Gimlas

GMSH to OPenFOAM - What am I doing wrong?

Ok, so I've tried to make a simulation of a complex geometry however I've failed to import GMSH .msh file into OpenFOAM. Therefore I've decide to practice a little bit on a very simple geometry. Yet,...

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -4. The time now is 00:35.