Search Results

Showing results 1 to 2 of 2
Search took 0.00 seconds. Search: Posts Made By: Ananthakrishnan

Forum: ANSYS Meshing & Geometry

April 29, 2013, 11:29

Replies: 12

[ICEM] Aspect Ratio is too high. ICEM

Views: 4,764

Posted By Ananthakrishnan

Hi, Theoritically it can cause some problems....

Hi,
Theoritically it can cause some problems. Just check the pre mesh orthogonal quality. If its too bad then you might have to change your blocking strategy a little bit at those places..If not you...

Forum: ANSYS Meshing & Geometry

April 28, 2013, 11:15

Replies: 12

[ICEM] Aspect Ratio is too high. ICEM

Views: 4,764

Posted By Ananthakrishnan

Hi, Just in case if you have not discovered...

Hi,
Just in case if you have not discovered this idea. Keep a uniform node distribution in the far field boundary. This will help reducing the aspect ratio as well. If not you might end up having...

Showing results 1 to 2 of 2

Forum Jump

All times are GMT -4. The time now is 21:50.