Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: Nicolastheterminator

Forum: ANSYS Meshing & Geometry

September 7, 2012, 09:53

Replies: 20

[ICEM] ~Howdy

Views: 2,856

Posted By Nicolastheterminator

Here is another cut-plane with the prisms

Here is another cut-plane with the prisms

Forum: ANSYS Meshing & Geometry

September 7, 2012, 09:51

Replies: 20

[ICEM] ~Howdy

Views: 2,856

Posted By Nicolastheterminator

Hi, I have tried to putting a mesh density at...

Hi,
I have tried to putting a mesh density at the trailing edge zone and I still have the same problem, I have attached 2 snapshots, one before prism, and one after the prisms. Also I get a much...

Forum: ANSYS Meshing & Geometry

September 7, 2012, 02:26

Replies: 20

[ICEM] ~Howdy

Views: 2,856

Posted By Nicolastheterminator

After which I smoother everything whilst freezing...

After which I smoother everything whilst freezing the prisms and the smoothed the prisms at 0.01. This does not make a difference, the low quality elements continue to stay there.

Forum: ANSYS Meshing & Geometry

September 7, 2012, 02:25

Replies: 20

[ICEM] ~Howdy

Views: 2,856

Posted By Nicolastheterminator

Hi, I used Octree, then deleted the quads,...

Hi,
I used Octree, then deleted the quads, smoothed the tri with Laplace, and then meshed with Delaunay which i smoothed by freezing the tris without Laplace. For prism settings i used 0.25 ortho,...

Forum: ANSYS Meshing & Geometry

September 6, 2012, 10:00

Replies: 20

[ICEM] ~Howdy

Views: 2,856

Posted By Nicolastheterminator

Hi, I've just done an unstructured mesh on my...

Hi,
I've just done an unstructured mesh on my model, but I get these low quality elements at the the trailing edge, i adjusted the edge criterion to 0.001 but the problem is still there?I have read...

Forum: ANSYS Meshing & Geometry

September 5, 2012, 10:28

Replies: 20

[ICEM] ~Howdy

Views: 2,856

Posted By Nicolastheterminator

Hey diamondx, Cool, thanks for directing me to...

Hey diamondx,
Cool, thanks for directing me to the calculator. I am working on hexa-meshing now, and am about to tackle a complex geometry. How would you recommend me to tackle?
Is it possible to...

Forum: ANSYS Meshing & Geometry

September 4, 2012, 10:44

Replies: 20

[ICEM] ~Howdy

Views: 2,856

Posted By Nicolastheterminator

~Howdy

Howdy,
I am new to ICEM CFD so forgive me if this is a relatively basic question. How do you know how many layers you need for a particular boundary layer? Do you use y+ or do you just simply guess...

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -4. The time now is 00:38.