Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: kad

Forum: ANSYS Meshing & Geometry

November 19, 2013, 17:52

Replies: 5

[ICEM] Tips dealing with problem tets/tri manually without complete remesh

Views: 2,033

Posted By kad

Generally prism should be a little easier with...

Generally prism should be a little easier with delaunay. The most important thing is to smooth the surface mesh with laplacian smoother before creating delaunay. You can also run alternating cycles...

Forum: ANSYS Meshing & Geometry

November 18, 2013, 18:13

Replies: 5

[ICEM] Tips dealing with problem tets/tri manually without complete remesh

Views: 2,033

Posted By kad

Just give delaunay a try. I never check for...

Just give delaunay a try. I never check for delaunay violations before generating the mesh and it works with a probability of 99% as long as the mesh is water tight.

In the thin areas you can use...

Forum: ANSYS Meshing & Geometry

November 18, 2013, 08:56

Replies: 5

[ICEM] Tips dealing with problem tets/tri manually without complete remesh

Views: 2,033

Posted By kad

You can throw away your volume mesh and replace...

You can throw away your volume mesh and replace it by delaunay, as the octree mesh transition isn't that good anyway. If there are only seven problematic elements, you can delete them and generate...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 16:39.