Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: MadsR

Forum: OpenFOAM Meshing & Mesh Conversion

August 7, 2013, 07:48

Replies: 23

[snappyHexMesh] sHM, 2D, foils, sharp edge

Views: 4,054

Posted By MadsR

Oh I didn't realise you had your wing in a tube....

Oh I didn't realise you had your wing in a tube. That's a bit unusual :)

Mads

Forum: OpenFOAM Meshing & Mesh Conversion

August 7, 2013, 03:20

Replies: 23

[snappyHexMesh] sHM, 2D, foils, sharp edge

Views: 4,054

Posted By MadsR

@skeptik: Um, did I understand you wrong?: Just...

@skeptik: Um, did I understand you wrong?: Just change the inlet velocities.

Mads

Forum: OpenFOAM Meshing & Mesh Conversion

June 3, 2013, 03:45

Replies: 23

[snappyHexMesh] sHM, 2D, foils, sharp edge

Views: 4,054

Posted By MadsR

@Ilya, my simplistic online...

@Ilya, my simplistic online blockMesh-preprocessor can't handle negative values for the x-coordinate. If you change those three points where x is negative in your airfoil geometry it seems to work. ...

Forum: OpenFOAM Meshing & Mesh Conversion

April 3, 2013, 04:40

Replies: 23

[snappyHexMesh] sHM, 2D, foils, sharp edge

Views: 4,054

Posted By MadsR

Yeah it is mine, trouble is if you have sharp...

Yeah it is mine, trouble is if you have sharp trailing edge. My generator creates o-meshes and expect some bluntness at the TE. If you just click "submit" without submitting any airfoil-data-file, it...

Forum: OpenFOAM Meshing & Mesh Conversion

April 2, 2013, 10:38

Replies: 23

[snappyHexMesh] sHM, 2D, foils, sharp edge

Views: 4,054

Posted By MadsR

I don't know if this is applicable to your case...

I don't know if this is applicable to your case (especially since it seems that you have a very sharp TE), but you could try my 2D airfoil mesher which generates a blockMesh file ready for OpenFOAM. ...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 09:56.