Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: BrolY

Forum: ANSYS Meshing & Geometry

December 21, 2012, 09:34

Replies: 7

[ICEM] Closed geometry?

Views: 2,596

Posted By BrolY

Can you share your geometry ? What tolerance...

Can you share your geometry ?

What tolerance did you specify ?
What is the smallest element size of your mesh ?

If your smallest element size is bigger than the gap between two curves, then...

Forum: ANSYS Meshing & Geometry

December 21, 2012, 07:31

Replies: 7

[ICEM] Closed geometry?

Views: 2,596

Posted By BrolY

Centroid of 2 points is ok. You don't mind about...

Centroid of 2 points is ok. You don't mind about the location, just put it in the middle of your geometry.

Forum: ANSYS Meshing & Geometry

December 21, 2012, 05:57

Replies: 7

[ICEM] Closed geometry?

Views: 2,596

Posted By BrolY

Close surface 1, 2 and 3. Leave the others open...

Close surface 1, 2 and 3.
Leave the others open in order to let the fluid flow inside your geometry.
Just create one body (fluid for example) and that should work.

I would strongly recommand to...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 07:49.