CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums

Search Results

Register Blogs Members List Search Today's Posts Mark Forums Read

Showing results 1 to 5 of 5
Search took 0.00 seconds.
Search: Posts Made By: obaid69
Forum: ANSYS Meshing & Geometry September 10, 2014, 09:38
Replies: 7
Ga
Views: 1,082
Posted By obaid69
Thanks Maxime Perelli for the response. I would...

Thanks Maxime Perelli for the response. I would be pleased to find the way back from face split but looks like its a one-way operation.
Thanks again
Regards,
Obaid
Forum: ANSYS Meshing & Geometry September 9, 2014, 09:40
Replies: 7
Ga
Views: 1,082
Posted By obaid69
Actually I did Face Split with Edge by copying...

Actually I did Face Split with Edge by copying the edges to each channel and then split face.
What I erred is not to recheck each channel before going to the next so that I could undo the mistakes....
Forum: ANSYS Meshing & Geometry September 8, 2014, 09:19
Replies: 7
Ga
Views: 1,082
Posted By obaid69
Gambit cleanup geometry problem

Take a look at fluid domain. (picture C)
Forum: ANSYS Meshing & Geometry September 8, 2014, 08:18
Replies: 7
Ga
Views: 1,082
Posted By obaid69
Gambit cleanup geometry problem

Dear Maxime Perelli,
Kindly find the attached images of full domain (B) and a closeup (A).
Regards,
Obaid
Forum: ANSYS Meshing & Geometry September 8, 2014, 05:22
Replies: 7
Ga
Views: 1,082
Posted By obaid69
Question Gambit cleanup geometry problem

Hello,
I am working with Gambit 2.3.16 to make a geometry of flow channel assembly. I am stuck after some mistakes done during face splitting which results in hard lines (dangling) that formed with...
Showing results 1 to 5 of 5

 
Forum Jump

All times are GMT -4. The time now is 07:56.