Home > Forums > Software User Forums > Siemens

Catalytic converter mesh

Mark Forums Read

Reply

Search this Thread

March 9, 2018, 03:53	Catalytic converter mesh	#1
Marax111 New Member Alessandro Join Date: Feb 2018 Posts: 3 Rep Power: 7	Hi everybody, which is the best mesh setting for a catalytic converter? What is it y+ ? Where i found it in the options? Thanks

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 05:38
[Other] conformed FSI mesh for unstructured fluid region	ashish.svm	OpenFOAM Meshing & Mesh Conversion	10	August 2, 2019 08:40
[ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters)	shubham jain	ANSYS Meshing & Geometry	1	April 10, 2017 05:03
[snappyHexMesh] Snappyhex mesh: poor inlet mesh	Swagga5aur	OpenFOAM Meshing & Mesh Conversion	1	December 3, 2016 16:59

All times are GMT -4. The time now is 06:17.