|
[Sponsors] |
February 25, 2002, 04:28 |
combustion model
|
#1 |
Guest
Posts: n/a
|
I'm trying to introduce the Magnussen combustion model to my SI engine model but at the time of combustion nothing happens. I cannot find clear instructions on how to set the various parameters for this model in the manuals. My parameters are currently:
ufactor: 0.5 mixture fraction: 1 no conditional enthalpy tscale adjust: standard reaction: C8H18 + 12.5O2 -> 8CO2 + 9H2O rate eqn: no products Amix: 4 Bmix: 0.5 reactant parameters: 02 fixed fraction 0.233 leading reactants: C8H18 products: CO2, H2O ignition fraction: 0.05 time: iteration knock model: off Ignition starts 10 deg BTDC and continues till the last time step.All the scalars have been defined and their concentrations in the cylinder set to: C8H18: 0.0665 O2: 0.1960 N2: 0.7375 When running the simulation, the fluid temperature in the combustion chamber gets up to 600K due to compression but no chemical reaction takes place.Is there any other parameters I need to set for the model to work? I would appreciate any suggestions. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
combustion model in premixed combustion chamber | wuyu | FLUENT | 9 | February 16, 2018 10:40 |
Combustion Model | Rachel | FLUENT | 3 | November 11, 2008 20:29 |
Sawdust Combustion-Non-premixed Combustion Model | Jessy | FLUENT | 1 | June 19, 2007 10:59 |
Model combustion | KOchzg | FLUENT | 0 | April 4, 2005 10:46 |
Combustion-which one is an appropriate model? | Shankar | FLUENT | 3 | February 16, 2004 15:57 |