batch mode run

October 3, 2002, 05:44

Hi, I'm trying to run in batch mode by typing the following command:

pro-xm -batch < input.inp> logfile.out

but then this error is in logfile.out:

**ERROR - COULD NOT OPEN UNIT 1 (HISTORY FILE)

Does anyone what I'm doing wrong. Help will be appreciated.

Cheers

Hennie

October 3, 2002, 10:13

Couple of possibilities:

1)You are running in a directory for which you have no write permission

2)There already is a history file in that directory and you either do not own it or it cannot be overwritten

3)None of the above in which case I guess I can't help.

October 3, 2002, 05:44	batch mode run	#1
hennie Guest Posts: n/a	Hi, I'm trying to run in batch mode by typing the following command: pro-xm -batch < input.inp> logfile.out but then this error is in logfile.out: **ERROR - COULD NOT OPEN UNIT 1 (HISTORY FILE) Does anyone what I'm doing wrong. Help will be appreciated. Cheers Hennie

October 3, 2002, 10:13	Re: batch mode run	#2
steve Guest Posts: n/a	Couple of possibilities: 1)You are running in a directory for which you have no write permission 2)There already is a history file in that directory and you either do not own it or it cannot be overwritten 3)None of the above in which case I guess I can't help.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Batch Mode	Titiksh Patel	FLUENT	13	February 1, 2010 15:48
batch mode	Peter Schaller	FloEFD, FloWorks & FloTHERM	2	October 6, 2008 04:18
Batch mode in WB.	cfdguy	CFX	1	June 24, 2008 07:49
Pre in batch mode	Kuts	CFX	7	August 17, 2007 06:10
DPM in Batch Mode	MM	FLUENT	0	December 15, 2006 14:17