How can I process the temperal flow of Star-CD?

October 17, 2002, 13:15

I'm beginning to use Star_CD. I would like to write a subroutine to process the temperal flow of each cell in the boundary of a pipe. But I cannot find the file which is used by Star_CD to store the temperal flow.

Is it possible to read and write that file to process the flow of the pipe?

October 31, 2002, 05:39

what is temperal flow?

For user inputed inlet flow, you can set it at the define inlet menu and set the choice from standard to user?

October 17, 2002, 13:15	How can I process the temperal flow of Star-CD?	#1
Miles Guest Posts: n/a	I'm beginning to use Star_CD. I would like to write a subroutine to process the temperal flow of each cell in the boundary of a pipe. But I cannot find the file which is used by Star_CD to store the temperal flow. Is it possible to read and write that file to process the flow of the pipe?

October 31, 2002, 05:39	Re: How can I process the temperal flow of Star-CD	#2
tailor02 Guest Posts: n/a	what is temperal flow? For user inputed inlet flow, you can set it at the define inlet menu and set the choice from standard to user?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Star-CCM+ uni-directional flow...	mk_mat	Siemens	8	November 12, 2007 08:33
mould flow in casting process	seeker01	Main CFD Forum	4	December 18, 2002 09:37
Star-CD for transonic flow	John McArthur	Siemens	2	April 26, 2001 09:36