|
[Sponsors] |
February 22, 2003, 07:17 |
Moving Mesh - ASI Off
|
#1 |
Guest
Posts: n/a
|
Hi,
I have a 2D model with moving meshes (ASI interface). All boundary regions, conditions, and meshes are correct (checked visually and using the incorporated StarCD checks). I then wrote the geometry and prob files with no probs. Then, went to command window and did PMOV LINK and STAR LINK, all okay except for a warning to increase some parameters in param.inc. Afterwhich, the program manages to run. HOWEVER, only giving zero values.. After opening casename.run and casename.info files, I found that ASI rematching is switched off. Why is this so when I followed all the commands from tutorial 7? PLease help... answer urgently needed.... Thanks so much, Jannet |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving Reference frame - UDF - Moving mesh | modisa | FLUENT | 0 | April 18, 2008 13:31 |
Moving Mesh & Not Rotating Mesh | AB | Siemens | 1 | October 25, 2004 03:10 |
moving mesh | Jim | Siemens | 2 | August 27, 2002 07:39 |
moving mesh | zqf | Siemens | 1 | June 19, 2002 01:30 |
moving mesh | khb | Main CFD Forum | 1 | June 5, 2002 10:46 |