Defining sensors

July 19, 2003, 15:58

Have sensors to lay inside cells or they may be defined at surface as well?

How to use command GPOST with option MAPLINE? I've tried to draw the line on the top of the current section plot, but the following error message appears: "THE VIEW IS PERPENDICULAR TO THE SECTION NORMAL".

July 22, 2003, 12:08

Sensors can be on a surface, but be careful that they are not outside the model. It appears from your error that you are trying to look at your section from its edge (ie perpendicular to the normal to the section). Define the section and then try view,snorm to force the viewing direction to be normal to the section.

July 19, 2003, 15:58	Defining sensors	#1
Julie Polyakh Guest Posts: n/a	Have sensors to lay inside cells or they may be defined at surface as well? How to use command GPOST with option MAPLINE? I've tried to draw the line on the top of the current section plot, but the following error message appears: "THE VIEW IS PERPENDICULAR TO THE SECTION NORMAL".

July 22, 2003, 12:08	Re: Defining sensors	#2
steve Guest Posts: n/a	Sensors can be on a surface, but be careful that they are not outside the model. It appears from your error that you are trying to look at your section from its edge (ie perpendicular to the normal to the section). Define the section and then try view,snorm to force the viewing direction to be normal to the section.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Defining of a geometry	Gabriella	FLUENT	1	October 15, 2008 06:15
how to model CO Sensors in Fluent	hari	FLUENT	0	October 22, 2007 00:16
Defining a zone	CFDNewbie	FLUENT	3	July 18, 2007 16:31
exporting the results of sensors in ascii file	george	Siemens	1	January 9, 2007 15:11
Defining New Variables	Tim	Phoenics	0	September 30, 2003 14:52