|
[Sponsors] |
March 19, 2004, 06:44 |
2-d problem BOUNDARIES IN prostar
|
#1 |
Guest
Posts: n/a
|
IN 2-D DIMENSION, THE BOUNDARIES HOW I CAN DEFINE THEM WITHOUT THE CURSOR, BUT ONLY WITH THE EDGES, WHICH ARE NOT SURFACES IN 2-D BUT SIMPLE LINES???
|
|
March 19, 2004, 08:03 |
Re: 2-d problem BOUNDARIES IN prostar
|
#2 |
Guest
Posts: n/a
|
STAR doesn't run 2D cases in this way: for a 2D simulation you require a 3D mesh, but there is only one cell in the third dimension. Change your mesh and all your boundaries will have a face, not just a line.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
block generation problem by PROSTAR | Mehdi | Siemens | 0 | April 26, 2006 06:34 |
Problem with export data from prostar | Shanta | Siemens | 1 | November 28, 2004 00:48 |
boundaries of my problem | muhkiraz | FLUENT | 2 | January 23, 2004 07:13 |
Problem: graphics display in prostar main window | Jiaying Xu | Siemens | 8 | February 14, 2002 09:08 |
Riemann problem at boundaries | K. I. Chan | Main CFD Forum | 0 | December 10, 2000 23:56 |