|
[Sponsors] |
May 28, 2004, 00:09 |
-ve pressure
|
#1 |
Guest
Posts: n/a
|
Hi All
I am doing one simple simulation involving pressure calculations. But my problem is that I am getting -ve abs pressures at zones where there are high velocities (region of small gap). I have tried refining the mesh. (all tets). But still I fail to get good solution. Kindly guide. Fluid is water. Pressure difference at inlet and outlet is 60psi(~4bar). What shall I do? thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What type of pressure can give the pressure drop | david | FLUENT | 1 | February 17, 2014 11:51 |
Pressure driven laminar flow simpleFoam pressure higher at the outlet than inlet | gabriel | OpenFOAM Running, Solving & CFD | 16 | September 30, 2009 18:20 |
Forcing pressure outlet according to pressure prob | Cedric | FLUENT | 0 | July 29, 2005 11:49 |
pressure driven flow by pressure correction method | justentered | Main CFD Forum | 0 | December 29, 2003 23:52 |
Total pressure to static pressure ratio | roadracer | Siemens | 1 | April 17, 2003 05:31 |