|
[Sponsors] |
April 16, 2003, 10:05 |
Total pressure to static pressure ratio
|
#1 |
Guest
Posts: n/a
|
Hi all. I have the following problem: flowbox of an engine manifold, Inlet BC stagnation, outlet BC pressure.Turbulent (ke) compressible flow. The reference pressure is 98000Pa, and the reference cell is on the pressure boundary. The total pressure is 2000Pa (relative). The calculations seems to run properly till convergence, but the output values of pressure are strange, and I have the warning message "ratio of total to static pressure (at stagnation boundary)less than 1..." The total pressure at inlet is 101432,static pressure at inlet is 101233. How can it be possible?
|
|
April 17, 2003, 05:31 |
Re: Total pressure to static pressure ratio
|
#2 |
Guest
Posts: n/a
|
Have you check the ratio of every cell in the inlet?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
static vs. total pressure | auf dem feld | FLUENT | 17 | February 26, 2016 13:04 |
total or static pressure? | George | Main CFD Forum | 0 | November 22, 2005 03:53 |
Static, Total pressure | DSS | Siemens | 1 | May 27, 2005 07:09 |
static or total pressure? | Tim | Phoenics | 1 | September 24, 2003 12:36 |
Static vs Total Pressure | Alfonso Ferrandez | FLUENT | 2 | May 23, 2000 08:53 |